A massive, nearly five-hour shutdown of the US aviation system that has disrupted more than 20,000 flights since Friday may have been the fault of a single router installed by government contractor L3Harris, government officials said on Saturday. It was only the second time since the attacks of 11 September 2001 that the US grounded all flights nationwide.

The Federal Aviation Administration ordered a nationwide ground stop at 3.54 pm East Coast time on Friday, 13 November, citing a telecommunications outage affecting air route traffic control centres. The ground stop was removed at 8.15 pm on Friday, but hundreds of flights were still delayed or cancelled that night, and more than 9,000 flights were cancelled on Friday and more than 5,000 on Saturday. An estimated 1.5 million passengers were left stranded.

L3Harris, a contractor, was replacing a section of the system's old and discontinued copper wire with new fibre optic lines in a remote location on Friday afternoon, Transportation Secretary Sean Duffy said on Saturday. The router in that location then started overloading the air traffic control system, causing communications disruptions. When officials could not locate the cause of the overload, they grounded flights nationwide.

Two sites under scrutiny

The issue affected communications at 17 of the FAA's 22 en route centres. According to the FAA, in a note released on Sunday, 15 November, the initial investigation indicates two potential locations as the reason for the excessive data flooding the systems: a radar site in Amarillo, Texas, and a radio communications site in El Dorado, Arkansas. L3Harris had been doing work at the El Dorado site, including deploying a new router.

The FAA said the network began receiving an extraordinary flood of traffic, about 1,000 connection attempts every four to five seconds. When L3Harris blocked those two locations from the network, the network stabilised. The broadcasting function was disabled on all the new routers as a precaution. The routers from both sites have been sent to a test lab in Florida for examination.

Contractor error or faulty equipment

Duffy said the problem was caused by "contractor error or a faulty piece of equipment". He said officials were working to determine whether it was user error or installer error from L3Harris, or whether the company installed a faulty router. "We haven't determined what the fault was," he said. L3Harris said it took the issue seriously and was supporting the FAA in its investigation.

The incident is the latest example of problems with the ageing US air traffic control telecommunications system. The routers being replaced are about 25 years old and were supposed to have been replaced in 2006. The FAA spends $1 billion a year maintaining its old copper wire system and is racing to replace it with fibre. L3Harris said it has completed more than 70 per cent of the planned conversion from legacy copper wires to a fibre-optic system. Officials have ruled out a cyberattack.